Here's another Pokemon request. A lot of people asked me to do this one too, so I decided to give it a shot. Drawing this was no easy feat, so I hope you enjoy this tutorial I made! (I think that I'm actually going to make this one intermediate.) :D
Draw out the basic outline of the dragon body as shown. On the head, the V-shape is for the jaw. These guidelines will be in blue the entire time so that they are easier to see.
Sketch out the top of the head and finish the inside of the jaw. Be sure to add in the three 'horn' lines on the top and side of the head. Curve down into the body.
Draw out the teeth and gums inside of the mouth and then draw the eye socket. Begin to draw in more of the body around the blue guideline.
Draw in the arms. They should look slightly mechanical and the arm itself should be in three separate parts. the fingers should be shaped like rounded rectangles and the claws should have slightly rounded tips. Then add in a bit more of the body along the blue guideline.
Remember during this step that the body has to be the same width throughout the whole drawing. Try to keep all the lines in proportion so they don't look strange. Just draw in more of the body and design as shown.
Finish the body on the left side and then draw in the design on the top of the body as shown.
Finish the end of the body and then draw the tail. At the end of the tail, there should be two right triangles on either side.
Erase all the blue guidelines and you know that you're getting closer to the end! :D Add in the double line design on all of the rectangle/triangle parts of the body/tail.
Here's the tough part: adding in the design. If you look at a picture of Rayquaza, it has a series of yellow circles and lines that make an intricate design on its body. That's what your going to have to draw. As long as you keep in mind that the body pivots and turns as it curls, you should be fine on where to place the design. Think of the Pokemon facing left and the design has to go on its side. After you finish the circle and line design on the body, draw in an eye in the socket as shown.
Here's the final step: your drawing should look similar to this. That's it! I know that was a bit long and challenging, but I hope this tutorial helped all of you to draw your own Rayquaza! Thanks and don't forget to rate and leave me a comment! ^_^
DragoArt members upload artwork and drawing tutorials! They are also allowed to leave comments on tutorials, profiles, etc. Many more features, as well; it's way better than just being a boring guest!